Pallet Fill Update

Just wanted to update on my Pallet Jump Fills! Since the post, I’ve made two other sets, and painted the “natural” version from the last post. Here’s what I’ve made, with instructions!

Stars and Stripes Fill
So this fill was pretty simple to make! It has the same hinge type as the previous pallet fills (read how to make that hinge here).

For the stars, I printed out a star shape on heavy cardstock, cut it out and used it as a stencil to paint the stars. This was done with a large paintbrush, with touchups afterwards done with a smaller paintbrush.

To prevent bleeding on the stencil, I find it helpful to start on the cardstock and paint towards the middle of the star, all the way along the edges. That way you aren’t pushing paint underneath the cardstock inadvertently going from the wood to the paper.

942547_10154210228493189_7200224048349508713_n

Lattice Fill
Another straightforward pallet pattern, I painted the top boards with yellow and green, and the bottom boards with straight black. Then, I used some old 1 foot lattice we had lying around our house and nailed it onto the bottom boards, overtop of the black paint. Makes for a nice hunter-y type fill, without the heavy lifting of boxes! These also have the standard hinge pattern.

13615291_10154477669933189_2335253703405110436_n

Rainbow Fill
My advice, don’t ever do this 😆 It takes a TON of time and back pain, but it looks awesome!

To draw out the rainbow, I took a measuring tape and pinned the end of it to the corner of the pallet. For the left pallet, I pinned it to the bottom right hand side, and for the right pallet, I pinned it to the bottom left hand side.

Take a measurement of what you want the “height” of your rainbow to be (basically the height of the pallet). Move the measuring tape around the circle, leaving marks at your desired distance as you go. Then, connect the dots! Rinse and repeat for each band of the rainbow. I use approximately 1.5″ bands, but that will depend on your pallet height.

12919854_10154218483273189_5505074105727709596_n

For this pallet, I elected to do a slightly different hinge configuration, so that I would be able to use the rainbow in multiple positions as shown in the photo above! This hinge was made by drilling a hole through the middle of the 2nd and 3rd boards of pallet. Then, get a long bolt that fits through your drilled holes and your door hinge’s holes, and a wing nut. Slide the long bolt through one of the holes, through your door hinge and secure it with the wing nut. This way, the hinge is detachable, and you can flip the pallets in any direction you like!

Hope you guys enjoy these designs, and let me know what you come up with!

Post a Comment

Your email is never shared. Required fields are marked *

*
*